Most common issues on this model
- Heat after a power surge
- Temperature control response
- Drawer front gap
- Heating element
- Thermostat
The WDU-30 is a 30-inch indoor warming drawer from a later DCS design, now a discontinued model. Its guide is shared with the WDUI, and it is typically built in under an oven or alongside a range.
When a drawer stops heating after a power surge, we look at the control board or the temperature control first, then the element and thermostat, because a surge can damage electronics that otherwise seem fine. If the temperature control does not respond when turned, we test it and the wiring behind it. An uneven gap along the front of the drawer usually points to the mounting or the glides, which we adjust or replace.
Parts for a discontinued drawer can be hard to find. We check them before work, quote a written price, and say plainly if it is not worth repairing. Our repairs are covered by 30 days of workmanship warranty. The rating label confirms the full model and serial number before we order.
Key features
- Indoor warming drawer, 30 inches wide
- Later DCS design
- Same guide as the WDUI
- Discontinued older model
My drawer stopped heating after a power surge. Can it be fixed?
Often yes. We test the control, the element and the thermostat to see what the surge damaged, and confirm the part before quoting. Parts for a discontinued model can be scarce.
Why is the gap around my drawer front uneven?
The mounting or the glides may have shifted with age. We inspect and adjust them, or replace worn parts if they can be found. Worn glides can also cause a gap.
Is the WDU-30 the same as the WDUI?
They share their guide, but they are different model numbers. We read the label so we order the correct parts. We confirm the number before ordering anything.
Book repair for your WDU-30
Book online in about a minute, or give us a call. Same-day appointments are available inside the Loop on most days, and next-day service across the rest of Houston.